MTS-INLINE-PA-CP 20-120mm R5

BARS INSPECTION SYSTEM

Product:

Bars with diameter from 20 to 120 mm

Length :

Minimum 2.5 meters

Bending :

≤3mm/m, total bending limit ≤ 3 % with constant performances at +/-2.5dB
in dynamic conditions of speed and sensitivity mentioned

Material :

Round bars , carbon steels, alloys steels and titanium

Surface condition :

Rolled, straightened, chamfering and shot blasted

Focal laws calculations :

Metalscan Focal Laws Calculation Wizard integrated in Lineview Software

Data presentation :

LINEVIEW Software to manage the inspection bench and UT setup
Automatic management of the inspection parameters
Data and reporting saving
Cscan, Bscan, Ascan and Stripchart

PLC Control :

Encoding
Up/down adjustment of the elevating table following diameter inspected
Paint markers integrated on the system
Filtration system

Detection performances :

LW Mode: typically FBH 0,7 mm and/or SDH 0,3×10 mm depending on the grade
SW Mode: typically notch 0,3×0,3×10 mm depending the surface condition

Number of probes :

Up to 2 sets of 6 probes for the LW and SW CW/CCW modes for round bars

Max speed :

Up to 2m/s depending on the diameter and type of defects inspected

pdf à télécharger Télécharger la fiche produit